Minelab MF5 Service Manual page 72

MF5 Service Manual
_________________________________________________________________________________________________________________
d. The Switch Sensitivity can now be removed from the chassis of the detector and replaced
if required.
Use care handling the flexible ribbon cable. These are internal components and will be easily
Do not use a soldering iron on the switch or the flexible ribbon cable.
e. Install the Switch Sensitivity as follows:
•
check each control switch has a clean and lightly greased O-ring correctly positioned on the
mounting face.
•
Carefully align the control switches and the flexible ribbon cable within the detector body.
Figure 91: Remove Sensitivity Knob
damaged if they are forced or misaligned.
O ring
Lock Washer
Nut 10mm
Figure 92: Switch Sensitivity
NOTE
NOTE
72