Disassembly And Reassembly Procedures; Speaker Pod - Minelab F3 Service Manual

F3 Field Service Manual – Level 1 Maintenance
3.

DISASSEMBLY AND REASSEMBLY PROCEDURES

Minelab F3 Tool Kit (Minelab Part No 3004-0018) is required for these
procedures. The kit comprises:
Minelab Part No Description
0005-0006 Silicon Grease (100g tube)
0005-0010 Silicon Sealant (75g tube)
8701-0009 Tubular Spanner 7/8"
8701-0010 F3 Coil Cable Pull through
8701-0011 Screwdriver Pozidrive No 1 250mm
8701-0012 M3 Hex T Driver
8701-0013 Flat blade screwdriver 6.5mm x 150mm
Note: Numbers in brackets on all figures refer to the item number from the
applicable figure.
3.1.

Speaker Pod

3.1.1. Speaker Pod Disassembly:
•
Remove battery pack and sensitivity endcap from the detector.
3004-0017
1
2
3 2701-0092
4 4003-0083
5 4003-0084
•
Invert detector and lay speaker pod in sensitivity endcap to protect ground
balance/audio reset button (or use other means to protect ground
balance/audio reset button).
•
Remove 3 screws (5) on underside of speaker pod.
Figure 7 Speaker Pod Exploded View
SPKR/GB SW POD KIT SVC F3
SPEAKER POD – TOP HALF
SPEAKER POD – LOWER HALF
DECAL SPEAKER/HANDLE F3
SCREW M3X10 SS (not part of Kit)
SCREW NO 3X12 SS
Figure 8 Speaker Pod Parts List
Page 12