Minelab MF5 Service Manual page 17

MF5 Service Manual
_________________________________________________________________________________________________________________
Figure 10: Remove Screw, 3mm Allen key. Four (4) M4x20mm and four (4) M4x35mm
•
Using a T20 Torx (star) driver unscrew all four (4) Screws Torx T20 (Three(3) M4x35mm and
One(1) M4x20mm) from the right side of the detector.
Four (4) Screws in the Chassis of the MF5 must have an O-ring on the Screw to seal (make
watertight) the detector. All Screws with an O-ring are Torx T20 and not Allen key (Hex socket).
The boltholes that require a Screw Torx T20 (with O-ring) are marked with a star (Torx)
Mark shows
where Torx
T20 Screw with
O ring is
required
Figure 11: Torx T20 Bolts with O ring seal
Note
17
O ring
Needed on all
Torx T20
Screws.