Oracle Database Appliance Service Manual page 102

Install Processor (CPU)
Each heatsink is labeled to indicate which side of the heatsink faces the memory modules
(DIMMs) when the heatsink is properly oriented.
Tighten the two Phillips screws alternately two full turns at a time until the
g.
screws are fully seated [5].
4. Return the server node to operation.
a. Install the air duct.
See
b. Install the server node top cover.
See
c. Install the server node into the system.
See
d. Power on the server node.
See
5. Clear the CPU faults.
a.
Log in to the server node as root using the Oracle ILOM CLI.
b. To view server node faults, type the following command to list all known
faults on the system:
->
Oracle ILOM lists all known faults, for example:
SP/faultmgmt
Targets:
0 (/SYS/MB/P0)
Properties:
Commands:
cd
show
c. To clear the fault, type the following command:
->
set /SYS/MB/P
For example, to clear a fault on P0:
-> set /SYS/MB/P0 clear_fault_action=true
Are you sure you want to clear /SYS/MB/P0 (y/n)?
102 Oracle Database Appliance Service Manual • February 2016
"Install Air Duct" on page
"Install Server Node Top Cover" on page
"Install Server Node Into System Chassis" on page
"Powering On Oracle Database Appliance (Original Version)" on page
show /SP/faultmgmt
n
clear_fault_action=true
96.
139.
y
140.
142.