Connecting To The Cli At The User End For The Srx100 Services Gateway - Juniper SRX100 Hardware Manual

SRX100 Services Gateway Hardware Guide
7.
8.
9.
NOTE: Most modems have an RS-232 DB-25 connector. You must separately purchase
an adapter to connect your modem to the RJ-45 to DB-9 adapter and Ethernet cable
supplied with the services gateway.
Related Topics

Connecting to the CLI at the User End for the SRX100 Services Gateway

To remotely connect to the CLI through a dial-up modem connected to the console
port on the services gateway:
1.
2.
3.
4.
Table 23: Port Settings for Connecting CLI at User End
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
5.
66
Connecting to the CLI at the User End for the SRX100 Services Gateway
Connect the modem to your telephone network.
Turn on the power to the modem.
Power on the services gateway by pressing the Power button on the front panel.
Verify that the LED on the front panel turns green.
Power
Connecting the Modem at the SRX100 Services Gateway End on page 64
Connecting to the CLI at the User End for the SRX100 Services Gateway on page
66
Connecting an SRX100 Services Gateway to the CLI Locally on page 62
Connecting an SRX100 Services Gateway to the CLI Remotely on page 64
Connect a modem at your remote location to a management device such as a
PC or laptop computer.
Start your asynchronous terminal emulation application (such as Microsoft
Windows HyperTerminal) on the PC or laptop computer.
Select the port to which the modem is connected (for example,
COM
Configure the port settings shown in Table 23 on page 66.
In the HyperTerminal window, enter
For more information on the AT commands, see the JUNOS Software
Administration Guide .
Value
9600
8
None
1
None
AT .
).
COM1