Initiating Fire Alarm Or Emergency Alarm; Chime On/Off; Adjusting The Speech Volume And The Volume Of The Keypad Beeps - Visonic PowerMaster-10 G2 User Manual

Initiating Fire Alarm
You can generate a fire alarm or a silent emergency alarm in disarmed & armed states, as follows:
PRESS
OR
for 2 seconds
To stop the alarm, press
Note: For UL Listed product,

Chime ON/OFF

Disable / enable the chime zones (see Appendix C) by alternate clicking of the
PRESS
CHIME indicator lights steadily when "chime on" is selected.
Note: For UL Listed Product, the Chime setting must be set to "Chime ON".
Adjusting the Speech Volume
The following diagrams show how to increase or decrease the loudness by clicking the <1> or<4> key
(assuming that the volume was at minimum/maximum to begin with).
PRESS RESULTING DISPLAY
VOLUME+
VOLUME+
VOLUME+
VOLUME+
(max)
1
This function is disabled in ACPO compliant version
2
Refers to PowerMaster-30 G2 with voice option only
D-304829 PowerMaster-10/30 G2 User's Guide
OPERATING THE POWERMASTER SYSTEM
1
or Emergency Alarm
RESULTING DISPLAY
FIRE ALARM
EMERGENCY
Then, if or when the system is
in the disarmed state:
READY HH:MM
(alternating)
READY MEMORY
and then key in your valid user code.
Emergency is ancillary use only.
RESULTING DISPLAY
CHIME ON
CHIME OFF
↓
READY HH:MM
2
and the Volume of the Keypad Beeps
PRESS RESULTING DISPLAY
VOLUME–
(max)
VOLUME–
VOLUME–
VOLUME–
key, as shown below:
13