A&D BA-T Series Instruction Manual page 126

For settings for RS-232C, refer to
Display settings: MENU key
USB specifications
Connector
Standards
Device class
Mini-B USB pin assignment
Signal
Pin No. Direction
name
1 VBUS
2 D-
3 D+
4 ID
5 GND
For settings for the USB interface, refer to
Display settings:
USB flash drive (USB host)
In the BA-T series, you can connect a USB flash drive to the USB type A connector.
You can save weighing data, etc. in the USB flash drive and import the data into Windows or macOS
computers easily. (No driver is required)
The balance weighing data, etc. are saved on the USB flash drive in the CSV format. You can save the
results of check functions as a PDF file. Change the USB data format as required.
A file called BAT_T
weighing data is saved there. Copy this file to your computer for managing data, etc.
After copying data to your computer, delete the BAT_T
new data is saved, the new data is appended to the next line of the old data. (A new file is not
generated.)
Caution
Do not connect anything other than a USB flash drive to the USB A type connector.
"13.13. RS-232C
RS-232C interface button
select [Baud rate], [Data bit, parity bit], [Data format].
Mini-B USB (female), (dedicated for USB flash drives) USB Type A
USB 2.0
HID (Human Interface Device)
CDC (Communication Device Class)
Description
Input Power+
Data
-
transmission-
Data
-
transmission+
- N.C.
- Power-
MENU key
USB interface button
[USB device mode], [Data format].
.csv is generated under the root directory of the USB flash drive and the
interface".
System settings button
In the [RS-232C interface] screen,
USB Type A connector for USB flash drives
Mini-B USB connector
"13.14. USB interface".
System settings button
In the [USB interface] screen, select
126
Communication button
: Quick USB
: Virtual COM
Communication button
.csv file. If a file with old data exists and
Display unit