A&D BA-T Series Instruction Manual page 105

Name
Pause between data
1
outputs
Auto feed
2
Auto re-zero after data
3
output
Back button
4
Settings in the red box are default values (factory settings).
Command settings
Display settings: MENU key
1 Terminator
2 AK (acknowledge), error code
3 Command time out
4 Back button
Name
Terminator
1
AK (acknowledge),
2
error code
Command time out
3
Back button
4
Settings in the red box are default values (factory settings).
C : Carriage return, ASCII 0Dh
R
When [AK (acknowledge), error code] is set to ON in the command settings, the balance always
responds to reception of all commands sent from a personal computer or a PLC. Checking the code that
is responded improves the reliability of the communication.
Balance response
When [AK (acknowledge), error code] is set to ON in the function table, the balance responds as
follows.
When a command requesting data is sent to the balance:
If the balance cannot send the requested data, it sends an error code (EC,Exx).
If the balance can output the requested data, it sends the requested data.
Setting value (setting
range)
OFF , 1.6 seconds
OFF , 1 line
OFF , ON
-
System settings button
Communication button
Command settings button
Setting value
(setting range)
C L , C
R F R
OFF , ON
No limit,
Limit to one second
-
Selects the pause between data outputs.
Selects the line feed after data output.
Sets the function to automatically set to zero after data
output.
Returns to the previous screen.
Data output button
[Command settings] screen
Selects the terminator for the output data.
Select the response (received, processing or process
completed) to all commands sent from PC or PLC.
Sets the command timeout.
Returns to the previous screen.
105
Description
Description
AK : Acknowledgment, ASCII 06h
L : Line feed, ASCII 0Ah
F