A&D BA-T Series Instruction Manual page 103

Data output mode
Display settings: MENU key
1
2
3
4
5
Name
Data output
1
mode
Key mode
2
setting
Bandwidth
3
Reference
4
Polarity
5
Display
6
refresh rate
Interval time*
7
Back button
8
Settings in the red box are default values (factory settings). "d" is a unit of readability.
You can change the data output timing for the balance in the [Data output mode] screen.
* Depending on the interval time and baud rate, all data may not be transmitted unless the baud rate is
increased.
For details about the data output mode, refer to
System settings button
Data output button
Setting value (setting range)
Key mode , Auto print mode,
Stream mode, Interval output mode
Output only when the display is stable ,
Output regardless of whether the
display is stable or unstable,
Output after the display becomes stable
10 d , 100 d, 1000 d
Zero point , Last stable value
Positive values only , Negative values
only, Both positive and negative values
5 times/second , 10 times/second
-
-
Data output mode button
6
7
8
Selects the output timing for the selected
data.
Selects the output condition for the weighing
value.
Selects the auto print bandwidth.
Selects the reference for the weighing
value.
Selects the auto print polarity.
Selects the display and output rate.
This is common to the setting described in
"13.1. Display
Sets the interval time for outputting the
weighing value.
Returns to the previous screen.
"19.1. Data output
103
Communication button
[Data output mode] screen
Description
settings".
mode".