Setting Window Of Arbitrary Waveform/Function Generator; Connect The Output End - Owon FDS Series User Manual

6.Use Arbitrary Waveform/Function Generator
2. Display the frequency/cycle.
3. Display the amplitude/high level.
4. Display the offset/low level.
5. Initial phase .
6. Figure A: Display the pulsewidth/duty ratio.
7. Figure A: Display the current waveform.
8.Figure B:Display the current modulation mode.
Setting Window of arbitrary waveform/function
generator
The display window of arbitrary waveform/function generator is located at the
upper right of the screen. Refer to Channel 1 for the descriptions of Channel 2.
Descriptions:
1. Select the channel.
2. Enable or disable the channel output.
3. Select the load: high resistance or Custom load(Range is a to
10kΩ,default is 50Ω).
4. Waveform selection area.
5. Output parameter setting area.

Connect the output end

Connect BNC cable to the output end of Channel 1 or Channel 2 signal
111