Connect Through A Router - Owon TAO 3000 Series Quick Manual

icon, click Utility. Select Function in the bottom menu. Select LAN Set in the left
menu. In the bottom menu, set the Type item as LAN, and select Set. In the right
menu, set IP and Port to the same value as the "Ports-settings" in the software in step
(3). Select Save set in the bottom menu, it prompts "Reset to update the config". After
resetting the oscilloscope, if you can get data normally in the oscilloscope software,
the connection is successful.
Figure 4-4 Set the network parameters of the oscilloscope

Connect through a router

(1) Connection. Use a LAN cable to connect the oscilloscope with a router, the LAN port
of the oscilloscope is in the right panel; the computer should be connected to the
router too.
(2) Set the network parameters of the computer. Since the oscilloscope can not
support obtaining an IP address automatically, you should assign a static IP address.
The Default gateway and Subnet mask should be set according to the router. Here we
set the IP address to 192.168.1.71, Subnet mask is 255.255.255.0, Default gateway is
192.168.1.1.
4.Communication with PC
23