HikRobot MV-CL042-91CM User Manual page 33

Follow steps below to set shaft encoder control.
Steps:
1. Click Encoder Control, and set Encoder Source A and Encoder Source B according to actual
demands.
2. Set Encoder Trigger Mode.
 Any Direction means that both forward and backward direction will trigger.
 Forward Only mean that only forward direction will trigger.
 Backward Only mean that only backward direction will trigger.
3. Set Encoder Counter Mode.
 Ignore Direction means that both forward and backward direction will count.
 Follow Direction means that the forward direction is valid, and Encode Counter will
increase.
 Backward Direction means that the backward direction is valid, and Encode Counter will
increase.
4. (Optional) Set max. counter value (0 to 32767) in Encoder Counter Max.
After reaching the max. value, it will be cleared automatically or you can clear manually by clicking
Encoder Counter Reset.
Camera Link Line Scan Camera
Figure 7-8 Counter Description
Figure 7-9 Set Encoder Counter Max
User Manual
·
24