C-3.2 Engine Controls And Instruments; C-3.2.1 Ignition Switch; C-3.2.2 Forward/Reverse Gear Switch - Terex Genie GTH-4013 Operator's Manual

C-3.2 ENGINE CONTROLS AND
INSTRUMENTS
■ C-3.2.1
Ignition switch
Five-position switch:
No circuit under voltage, key can be removed
and engine is stopped
Circuits under voltage, presetting for the engine
starting. Board controls and instruments are on.
Thermal starter for cold climates. Rotate the key
in this position and wait until the warning light
7.2 signalling the glow plugs preheating goes
off; then rotate it to stroke end and start the
engine
Engine starting; when released, key springs back
to pos. I automatically.
Position of the ignition key to switch the controls
P
from cab to platform.
P
Handler with telescopic boom GTH-4013
OPERATING INSTRUCTIONS
■ C-3.2.2
Three-position switch with lock in neutral position:
0
1
2
The engine can be started only if selector 31 is to
the neutral "0" position.
C-9
Page
Document 57.0007.0200 - 01/2006
Forward/reverse gear selector switch
Neutral position; no gear engaged
Shift lever to pos. 1 to select the forward gear
Shift lever to pos. 2 to select the reverse gear
IMPORTANT
31
1
0
2