Table of Contents
Advertisement
■ C-4.4
LOW TEMPERATURE STARTING
In case of cold starting, use an oil with a SAE viscosity
adequate to the ambient temperature.
Please refer to the engine use and maintenance manual.
The machine is supplied with oil SAE 15W/40.
To start the engine from cold, proceed as follows:
•
Put the mechanical gear lever to neutral.
•
Turn the ignition switch to position
until the warning light 7.2 signalling the glow plugs
preheating goes off. Step down on the gas pedal
and start the engine turning the ignition switch to
position
. Release as soon as the engine starts..
•
Let the engine run at idle for a few seconds before
putting a gear; this allows for a gradual warm up of
the engine oil and a better lubrication.
Handler with telescopic boom GTH-4013
OPERATING INSTRUCTIONS
and wait
C-28
Page
Document 57.0007.0200 - 01/2006
Advertisement
Table of Contents
