Table of Contents
Advertisement
■
D-3.10 CHANGING THE OIL FILTER CARTRIDGE
To change the hydraulic oil filter element, proceed as follows:
1 Stop the machine on a level ground and engage the parking
brake.
2 Place a container of suitable size under the filter to collect
any oil leaks.
3 Remove the filter cover
4 Change the filter element, then, before fitting a new one,
thoroughly clean and grease both seat and gasket.
5 Refit and tighten the filter cover.
ATTENTION
Hydraulic oil filter canisters cannot be cleaned or washed
and refitted.
They must be replaced with new ones of the type
recommended by the manufacturer
PROTECT THE
ENVIRONMENT
The handling and disposing of used oils may be ruled by
local or national regulations. Address to authorised centres.
SERVICE INTERVAL
Running-in ____________________________ None
Ordinary __________________ Every
Handler with telescopic boom GTH-4013
MAINTENANCE
to get access to the filter element.
(see par.
D-5.2.2).
500
hours
Page
Document 57.0007.0200 - 01/2006
D-15
Advertisement
Table of Contents
