C-3.2.7 Steering Mode Selection; C-3.2.8 Cab/Road/Platform Changeover Switch - Terex Genie GTH-4013 Operator's Manual

■ C-3.2.6
Speed controls
13 Mechanical gearbox pushbutton
Used to engage the 1
Push the button to select the required
speed.
Each pressure corresponds to the
selection of a new speed.
ATTENTION
Do not change gear when the machine is running.
IMPORTANT
When a gear is not correctly put, the warning light
7.14 comes on (see C-3.3.2).
Handler with telescopic boom GTH-4013
OPERATING INSTRUCTIONS
st nd
or 2 gear.
C-12
Page
Document 57.0007.0200 - 01/2006
■ C-3.2.7
Steering mode selection
6 Steering mode switch
Three-position switch for the selection
0
1 2
of the steering mode:
1 Crab steering
0 Two-wheel steering
2 Four-wheel steering
■ C-3.2.8
Cab/road/platform switch
33 Switch
Three-position switch:
1 Rotate the switch to position 1 to
0
select the job-site setting and ope-
1 2
rate the handler by the cab controls
2 Rotate the selector switch to
position 0 to select the road setting
3 Rotate the switch to position 2 to
remove the ignition switch key and
operate the handler by the platform
controls. The green light indicator
lights up.
10
RPM x 100
5
0
15
20
25
30
P