Table of Contents
Advertisement
•
When entering/leaving the cab or other raised
parts, always face the machine; never turn the
back.
•
When carrying out operations at hazardous heights
(over 1.5 meters from the ground), always use
approved fall restraint or fall arrest devices.
•
Do not enter/leave the machine while it is running.
•
Do not leave the driving place when the machine
is running.
•
Neither stop nor carry out interventions under or
between the machine wheels when engine is
running. When maintenance in this area is required,
stop the engine.
•
Do not carry out maintenance or repair works
without a sufficient lighting.
•
When using the machine lights, the beam should
be oriented in order not to blind the personnel at
work.
•
Before applying voltage to electric cables or
components, check their connection and proper
functioning.
•
Do not carry out interventions on electric
components with voltage over 48V.
•
Do not connect wet plugs or sockets.
•
Plates and hazard warning stickers shall never be
removed, hidden or become unreadable.
Handler with telescopic boom GTH-4013
SAFETY PRECAUTIONS
•
•
•
•
•
•
•
Any intervention on the hydraulic circuit must be
carried out by authorised personnel.
The hydraulic circuit of this machine is fitted with
pressure accumulators. You and others could be
seriously injured if accumulators are not completely
depressurised.
For this purpose, shut the engine down and step
on the brake pedal 8
B-6
Page
Document 57.0007.0200 - 01/2006
Except for maintenance purposes, do not remove
safety devices, shields, protection cases, etc.
Should their removal be necessary, stop the engine,
remove them with the greatest care and always
remember to refit them before starting the engine
and using the machine again.
Before any maintenance or repair work, stop the
engine and disconnect the batteries.
Do not lubricate, clean or adjust moving parts.
Do not carry out operations manually when specific
tools are provided for this purpose.
Avoid the use of tools in bad condition or use in an
improper way i.e. pliers instead of adjustable
wrenches, etc.
Applying loads in different points of the attachment
holding plate is forbidden.
Before carrying out operations on hydraulic lines
under pressure or disconnecting hydraulic
components, ensure the relevant line has been
previously depressurised and does not contain any
hot fluid.
DANGER
÷
10 times.
Advertisement
Table of Contents
