Club Car Carryall 295 Maintenance And Service Manual page 381

DRIVETRAIN COMPONENTS
2210
Figure 17-20 Forward/Reverse Shifter Cable Ball Socket
At Shifter Handle Ball Stud
NOTE: Note the positions of the flanged nuts on the cable. The nut farthest from the handle should be at the farthest
end of the threaded portion of the cable.
5. Remove the passenger seat.
6. Note the positions of the wire ties that secure the cable between the dash and the transmission and then remove
the wire ties.
7. Disconnect the cable ball socket from the ball stud on the transmission shifter arm (Figure 17-22, Page 17-17).
8. Loosen the flanged nuts from the cable bracket that is below and forward of the transmission shifter arm. See
following NOTE.
NOTE: Note the positions of the flanged nuts on the cable. This hardware will be used to adjust the handle position
during installation.
Secure a heavy nylon cord to the transmission end of the cable. Pull the cord and cable at the dash frame
from the transmission and allow the cord to travel under the body.
9. Remove the shifter cable.
2212
Figure 17-22 Forward/Reverse Shifter Cable
at Transmission
2211
Figure 17-21 Forward/Reverse Shifter Cable Flanged Nuts
2008-2012 All-Wheel Drive Maintenance and Service Manual
Transmission
At Shifter Handle Bracket
17
Page 17-17