Club Car Carryall 295 Maintenance And Service Manual page 95

HYDRAULIC AND PARK BRAKE SYSTEMS
2039
Figure 6-24 Park Brake Cable Attachment
Left Rear Cable Removal
1. Chock the rear wheels and release the park brake.
2. Remove the P-clamp and nylon wire tie securing the cable to the frame.
3. Remove the C-clip from the right rear cable sheath adjacent to the caliper.
4. Slide the cable forward to release the sheath ferrule from the caliper bracket.
5. Move the cable up and toward the rear of the vehicle to remove the cable end from the caliper arm (Figure
6-24, Page 6-29).
6. Squeeze the ferrule tines together on the cable end at the frame bracket and remove the cable from the vehicle
(Figure 6-25, Page 6-29).
Right Rear Cable Installation
1. Install the caliper end of the cable into the brake caliper arm (Figure 6-24, Page 6-29).
2. Slide the sheath ferrule through the hole in the caliper mounting bracket.
3. Install a C-clip to hold the cable ferrule in place.
4. Route the cable up and across the air filter box and secure the P-clamp and cable to the top bolt on the filter
mounting bracket (Figure 6-26, Page 6-30).
5. Route the cable end to the outside of the air intake hose.
6. Secure the cable to the frame bracket at the outside hole (Figure 6-25, Page 6-29).
7. Insert the threaded end of the cable through the frame bracket. Use the nuts to adjust the cable end. Both cables
should be equal in length. Tighten the nuts to 40 ft-lb (54 N·m).
8. Secure the cable to the frame with a nylon wire tie.
9. Secure cable end to the equalizer bracket.
2040
2008-2012 All-Wheel Drive Maintenance and Service Manual
Park Brake System
Figure 6-25 Park Brake Frame Bracket
6
Page 6-29