Club Car Carryall 295 Maintenance And Service Manual page 79

HYDRAULIC AND PARK BRAKE SYSTEMS
Press ram
10
1
2030
9.2. Shim the ball joint arms (2 and 3) with steel blocks to provide a level surface for bearing removal (block
2 height is 9/16" and block 3 height is 1-11/16").
9.3. Make special bar (10), that fits inside cutouts of the bearing cavity opening (7), to rest on the outer race of
the bearing. Press out bearing.
10. Install a new bearing on the disc and hub.
10.1.Position the upright on 2 x 2-inch, or larger, steel blocks (1) as shown (Figure 6-12, Page 6-13).
10.2.Position a new bearing (7) into the bearing cavity of the upright.
10.3.Use a bar or rod (8) slightly smaller than the outside diameter of the bearing, but large enough to engage
the outside bearing race, to press the bearing into the bearing cavity until it bottoms out. See following
CAUTION.
CAUTION
• Press against the entire bearing surface.
• Bearing must seat completely in cavity. There should be no gap between the bearing and the lip of the
upright. The bearing should be flush with the non-lip side of the upright.
8
1
2031
Figure 6-12 Position Upright for New Bearing
7
5
1
Figure 6-11 Bearing Removal
7
5
1
2032
2008-2012 All-Wheel Drive Maintenance and Service Manual
Brake Disc and Hub – 2008-2011 Models
2.835 in. (72 cm)
2.909 in. Max. (73.9 cm Max.)
.281 in.
(7 mm)
10
Radius
8
5
6
Figure 6-13 Press Disc and Hub into Bearing
6
1/2 in.
(12 mm)
7
1
Page 6-13