Thermostat Switch; Testing The Thermostat Switch; Thermostat Switch Removal - Club Car Carryall 295 Maintenance And Service Manual

Hide thumbs Also See for Carryall 295:
Table of Contents

Advertisement

14

Thermostat Switch

1.
Attach the connector harness to the halogen bulb. The retaining tab should lock onto the halogen bulb (Figure
14-16, Page 14-17).
2.
From the front of vehicle, reach under the cowl and insert the bulb assembly into the headlight lens.
3.
Turn the bulb assembly counterclockwise one-quarter turn.
4.
Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
THERMOSTAT SWITCH
See General Warnings, Section 1, Page 1-2.

TESTING THE THERMOSTAT SWITCH

See Test Procedure 10 – Thermostat Switch on page 12-22.

THERMOSTAT SWITCH REMOVAL

1.
Disable the vehicle. See Disabling the Vehicle on page 1-3.
2.
Disconnect the two-pin connector between the thermostat switch and the wire harness (Figure 14-17, Page
14-18). See following WARNING.
WARNING
• Hot! Coolant system is pressurized. Do not remove thermostat switch while engine is hot.
3.
Loosen the radiator cap to relieve pressure.
4.
Unscrew the thermostat switch from the engine block. See preceding WARNING.
2147
Figure 14-17 Thermostat Switch
Page 14-18
2008-2012 All-Wheel Drive Maintenance and Service Manual
ELECTRICAL COMPONENTS: DIESEL VEHICLES

Advertisement

Table of Contents
loading

This manual is also suitable for:

Carryall 295 seCarryall xrt 1550Xrt 1550 se

Table of Contents