Club Car Carryall 295 Maintenance And Service Manual page 378

17
Transmission
3. Remove the drive belt. See Drive Belt Removal on page 15-31 (gasoline vehicles) or Drive Belt Removal on
page 16-27 (diesel vehicles).
4. Remove the drive clutch. See Drive Clutch Removal – Both Designs on page 15-32 (gasoline vehicles) or
Drive Clutch Removal – Both Designs on page 16-28 (diesel vehicles).
5. Remove the driven clutch. See Driven Clutch Removal on page 15-38 (gasoline vehicles) or Driven Clutch
Removal on page 16-34 (diesel vehicles).
6. Remove the rear driveshaft. See Rear Driveshaft Removal on page 17-13.
7. Remove the clutch inner cover. See Clutch Inner Cover Removal on page 15-41 (gasoline vehicles) or Clutch
Inner Cover Removal on page 16-37 (diesel vehicles).
8. Remove the passenger seat.
9. Remove the transmission Forward/Reverse shifter cable ball socket from the ball stud on the transmission
shifter arm (Figure 17-22, Page 17-17).
10. Disconnect the neutral sensing connector from the transmission (Figure 17-17, Page 17-14).
2207
Figure 17-17 Neutral Sensing Connector
11. Remove the two flange-head bolts, washers, and locknuts from the transmission slotted base brackets and
engine mounting plate. See following NOTE.
NOTE: If the transmission is replaced, remove the base brackets and corresponding hardware. Use new hardware
and the existing base brackets to install the new transmission. Tighten the base bracket hardware to
39 ft-lb (53 N·m).
If the transmission is not replaced, leave the base brackets attached to help stabilize the transmission during
repair.
12. Lift the transmission body slightly to clear the opening in the engine mounting plate and remove the transmission
from the rear of the vehicle sliding the splined shaft out of the front driveshaft.
Page 17-14 2008-2012 All-Wheel Drive Maintenance and Service Manual
DRIVETRAIN COMPONENTS