Club Car Carryall 295 Maintenance And Service Manual page 234

12
Test Procedures
2102
Figure 12-41 Bed Lift Motor Voltage Reading with Switch
in UP position
TEST PROCEDURE 37 – Bed Lift Switch
1. Remove the bed lift switch. See Bed Lift Switch Removal on page 14-9.
2. Check continuity between the terminals (Figure 12-43, Page 12-44) of the switch and compare the readings with
the Bed Lift Switch Continuity Table. If continuity readings do not match the table, replace the switch. See Bed
Lift Switch Installation on page 14-9.
1
2
4
A. Up Position B. Down Position
1. #14 Black w2 2. #14 Red w3 4. #14 Red w7 5. #14
Red w7 6. #14 Yellow w5 8. #14 Black w2
2104
Figure 12-43 Bed Lift Switch Terminals (Rear View)
Page 12-44 2008-2012 All-Wheel Drive Maintenance and Service Manual
A
5
6
8
B
Terminal:
TROUBLESHOOTING AND ELECTRICAL
2103
Figure 12-42 Bed Lift Motor Voltage Reading with Switch
in DOWN position
SYSTEM: DIESEL VEHICLES