Club Car Carryall 295 Maintenance And Service Manual page 385

DRIVETRAIN COMPONENTS
Rear Wheel Bearing Removal
1. Remove the axle tube (1) from the differential (Figure 17-25, Page 17-21). See Rear Differential and Axle
Shaft Removal on page 17-19.
2. Remove the retaining ring (2) that is in front of the bearing (3) (Figure 17-25, Page 17-21).
3. Drive bearing from axle tube by applying force to the outer race.
2215
Figure 17-25 Rear Wheel Bearing
Rear Wheel Bearing Installation
1. Clean inside axle tube where new bearing will sit and lightly lubricate the bore with anti-seize compound.
2. Using an appropriate sized bearing driver that fits the outer race, drive in new bearing until fully seated.
3. Install the retaining ring.
4. Clean axle shaft and carefully install axle tube to avoid damaging new seals. See Rear Differential and Axle
Shaft Installation on page 17-20.
1
2008-2012 All-Wheel Drive Maintenance and Service Manual
Rear Differential and Axle Shafts
17
Page 17-21