Club Car Carryall 295 Maintenance And Service Manual page 189

TROUBLESHOOTING AND ELECTRICAL SYSTEM:
GASOLINE VEHICLES
TEST PROCEDURE 36 – Bed Lift Switch
1. Remove the bed lift switch. See Bed Lift Switch Removal on page 13-10.
2. Check continuity between the terminals (Figure 11-36, Page 11-39) of the switch and compare the readings
with the Bed Lift Switch Continuity Table. If continuity readings do not match the table, replace the switch.
See Bed Lift Switch Installation on page 13-10.
1
2
4
A. Up Position B. Down Position
Terminal:
1. #14 Black w2 2. #14 Red w3 4. #14 Red w7 5. #14
Red w7 6. #14 Yellow w5 8. #14 Black w2
2104
Figure 11-36 Bed Lift Switch Terminals
Between 1
Terminals
1
2 Cont. when
pushed DOWN
4
5
6
8
TEST PROCEDURE 37 – Bed Lift Circuit Breaker
1. Remove the bed lift circuit breaker. See Bed Lift Circuit Breaker Removal on page 13-10.
2. Place the red probe of the multimeter on the circuit breaker terminals. If the multimeter does not indicate
continuity, replace the circuit breaker. See Bed Lift Circuit Breaker Installation on page 13-11.
A
5
6
8
B
BED LIFT SWITCH CONTINUITY
2
Cont. when
pushed DOWN
Cont. when
pushed UP
2008-2012 All-Wheel Drive Maintenance and Service Manual
4 5
Cont. when
pushed UP
Cont. when
pushed DOWN
Test Procedures
6 8
Cont. when
pushed DOWN
Cont. when
pushed UP
Cont. when
pushed UP
Page 11-39
11