Setting The Reset Peak Switch Utilization - Cabletron Systems 2H23-50R User Manual

Chapter 5: Local Management
The following briefly defines each field of the System Resources screen.
CPU Type (Read-only)
Indicates the microprocessor used in the 2H23-50R or 2H33-37R.
Flash Memory Installed (Read-only)
Indicates the amount of FLASH memory installed in the 2H23-50R or
2H33-37R and how much is currently available.
DRAM Installed (Read-only)
Indicates the amount of DRAM installed in the 2H23-50R or 2H33-37R
and how much of it is currently available.
NVRAM Installed (Read-only)
Indicates the amount of NVRAM installed in the 2H23-50R or 2H33-37R
and how much of it is currently available.
Current Switch Utilization (Read-only)
Shows the percentage of the device switching capacity currently being
used.
Peak Switch Utilization (Read-only)
Shows the peak percentage of device switching capacity used, since the
last reset.
Reset Peak Switch Utilization (Toggle)
Enables the user to reset the Peak Switch Utilization field. The switch
may be set to either YES or NO as described in
the Peak Switch Utilization field to the current system traffic.

5.12.1 Setting the Reset Peak Switch Utilization

To set the Reset Peak Switch Utilization field to YES or NO, proceed as
follows:
1. Use the arrow keys to highlight the Reset Peak Switch Utilization
field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message "SAVED OK" displays.
5-46
Section
2H23-50R/2H33-37R User's Guide
5.12.1. YES resets