Drive Train/Brake Disc - Arctic Cat 660 cc Service Manual

Drive Train/Brake Disc

DISASSEMBLING
1. Remove the chain-case drain plug located on the
lower back side of the chain case inside the tunnel
and drain the chain case lubricant.
2. Open the belt guard.
NOTE: For removing drive belt on models with
the ACT Roller Driven Pulley, see Removing/
Installing Drive Belt in this section.
3. Remove the drive belt.
4. Remove the cap screw and washer securing the
driven pulley; then account for and note the
position of any alignment washers.
5. Slide the driven pulley off the driven shaft; then
remove the driven pulley from the engine
compartment. Account for the key, stub shaft (on
the Bearcat and T660 Touring), and alignment
washers.
NOTE: On the Bearcat and T660 Touring if the
driven pulley is tight on the driven shaft, pull the
driven pulley off using the Driven Pulley Puller (p/n
0744-023).
Back
8-36
SC013D
AO372
Back to TOC
6. Disconnect the shift linkage from the arm on chain
case.
7. Remove the cap screw from the center of the chain
case.
8. Remove the cap screws securing the chain case
cover; then remove the cover by pulling outward
and lifting up so the shift fork clears the large
inner washer.
9. Remove the screw from the chain adjuster housing
and install an 8-32 set screw to lock the chain
adjuster in position.
Back to Section TOC
AF120D
AI025
AI010
Next