Arctic Cat 660 cc Service Manual page 332

2. Inspect the end cap for any signs of cracking or
wear.
3. Clean both the slide rail area and the end cap.
Using compressed air, clean the areas of dirt and
gravel.
! WARNING
Always wear an approved pair of safety glasses
when using compressed air.
4. Inspect the cap screw for cracked, stretched, or
damaged threads. Use a new lock nut when assem-
bling.
Back
AG507D
AG508D
Back to TOC
INSTALLING
1. Position the end cap on the slide rail; then align the
hole in the end cap with the hole in the slide rail.
2. Secure with a cap screw, washers, and lock nut.
Tighten to 1.1 kg-m (8 ft-lb).
Shock Pads
NOTE: The skid frame does not have to be
removed for this procedure.
REMOVING
NOTE: The shock pads should be removed only
if being replaced.
1. Twist the push nuts off the soild rivets securing the
shock pads.
2. Remove the shock pads.
INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect the pads for damage or wear.
2. Inspect the rivet holes in the slide rail for damage
or elongation.
INSTALLING
1. Place the pads into position on the slide rail.
2. Secure the pads with new push nuts.
Back to Section TOC
9
Next
9-59