Arctic Cat 660 cc Service Manual page 331

3. Using a straightedge, inspect the slide rail for any
unusual bends. Place the straightedge along the
bottom surface of the slide rail. If the rail is found
to be bent, it must be replaced.
INSTALLING
NOTE: Apply a light coat of grease to the slide
rail surface to aid in installing a new wear strip. If
there are any sharp edges on the lower portion of
the rail, use a file to remove them.
1. From the back, start the wear strip onto the rail;
then using a block of wood and a hammer, drive
the wear strip forward into position.
Back
9-58
AG529D
AG536D
AG534D
Back to TOC
2. Secure with a machine screw and lock nut.
Tighten to 1.1 kg-m (8 ft-lb).
End Caps
NOTE: The skid frame does not have to be
removed for this procedure.
REMOVING
1. Remove the lock nut, washers, and cap screw
securing the end cap.
2. Using a hammer, tap the end cap off the rail.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect the end cap area of the slide rail for cracks
and wear.
Back to Section TOC
AG535D
AG506D
Next