Arctic Cat 660 cc Service Manual page 78

25. Secure the throttle body cable bracket to the intake
plenum with the two 6 mm cap screws; then
connect the throttle cable end to the throttle body.
26. Install the cable adjuster to the cable bracket,
adjust the cable, and tighten the jam nuts securely.
27. With the grafoil gasket positioned in the muffler,
install the muffler into the support brackets and to
the exhaust manifold.
28. Using Spring Pliers (p/n 0644-391) or (p/n 0644-
397), install the two springs securing the muffler
to the support brackets; then install the two springs
to the exhaust manifold.
Back
2-66
AO189
MD1730
AO180
Back to TOC
29. Install the ECU to the bracket in the chassis and
secure with the two #27 torx-head cap screws.
30. Connect the main harness connectors in the
chassis.
31. Install the fuse block making certain the tabs are
locked in place.
32. If the hood was removed for this procedure, place
the hood into position on the front mounts; then
install the two pivot cap screws and attach the
hood cable with the hairpin clip.
! CAUTION
Take care not to damage the windshield when
installing the hood.
Back to Section TOC
AO267
AO184A
AO185
Next