Replacing Water Pump - Arctic Cat 660 cc Service Manual

Replacing Water Pump

! CAUTION
Before doing
disconnect the negative battery cable to avoid
injury.
1. Drain the engine coolant (see Liquid Cooling
System in this section).
2. Remove the air silencer (see appropriate Servicing
Air Silencer in this section).
3. Remove the two cap screws and one lock nut
securing the engine belt cover to the engine.
4. Loosen the upper and lower alternator cap screws;
then push the alternator toward the engine and
remove the belt.
5. Remove the springs securing the muffler to the
exhaust manifold and chassis; then unplug the
oxygen sensor.
Back
this servicing procedure,
Back to TOC
6. Remove the exhaust manifold shield and account
for the three 6 mm cap screws.
7. Remove the exhaust manifold and account for the
four copper nuts and two cap screws.
AO265
AO266
Back to Section TOC
AO267
3
AO279
AO268
AO269
Next
3-21