Arctic Cat 660 cc Service Manual page 195

INSTALLING (Touring)
KEY
1. Backrest
2. Cover
3. Axle
4. Cup Washer
5. Tension Block
6. Machine Screw
7. Adjuster Arm
8. Spacer
9. Machine Screw
10. Retaining
Screw
11. Lens
12. Gasket
13. Bulb
14. Housing
15. Cover
16. Washer
17. Nut w/Washer
18. Bracket
19. Decal
20. Decal
21. Machine Screw
22. Plate
23. Switch
24. Bracket
25. Cap Screw
26. Warmer
Harness (R)
1. Place the backrest assembly and spacers (located
on the rear hole on each side) into position and
align holes with tunnel mounting holes.
2. Install the cap screws with washers from the inside
of the tunnel and secure with the washers and lock
nuts. Tighten securely.
3. In turn on each side, install the 1/4-in. cap screw in
the front hole and the 5/16-in. cap screw in the rear
hole. Secure with a flat washer and lock nut.
Tighten securely.
4. Connect the passenger handwarmer wiring
harness.
INSTALLING (Bearcat)
KEY
1. Seat Riser (R)
9. Rivet
2. Seat Riser (F) 10. Cap Screw
3. Seat Riser (R) 11. Backrest
4. Seat Riser (L) 12. Cover
5. Rivet 13. Axle
6. Bracket 14. Cup Washer
7. Bracket 15. Tension Block
8. Wind Deflector 16. Machine Screw
Back
7-36
27. Warmer
Harness (L)
28. Washer
29. Retainer
30. Bracket
31. E-Ring
32. Retainer
33. Lever
34. Washer
35. Washer
36. Reflector
37. Clip
38. Retainer
39. Self-Tapping
Screw
40. O-Ring
41. Warmer
Element
42. Handgrip
43. Lever
44. Washer
45. Handhold
46. T-Nut
47. Self-Tapping
Screw
48. Washer
49. Deflector
0738-795
Back to TOC
5. Place the rack into position and secure with the
cap screws, washers, and cap.
REMOVING (Bearcat)
1. Remove the four cap screws securing the backrest
brackets to the rack assembly.
2. Drill the rivets out of the left and right side
brackets securing the tunnel assembly and the
front and rear risers.
3. Remove the eight lock nuts and cap screws
securing the rack assembly to the tunnel.
KEY
1. Rack
2. Mat
3. Guard
4. Lock Nut
5. Machine Screw
6. Lens
7. Housing
8. Bulb
9. Machine Screw
10. Lock Nut
11. Pin
12. Hitch
13. Latch
14. Cap Screw
Back to Section TOC
0738-525
15. Lock Pin
16. Clip
17. Spring
18. Cap Screw
19. Cap Nut
20. Washer
21. Plug
22. Reflector
23. Clip
24. Decal
25. Decal
26. Decal
27. Decal
0738-796
Next