Arctic Cat 660 cc Service Manual page 352

13. Remove the cap screw (A), lock washer, and lock
nut from the rear arm limiter shaft.
14. Remove the cap screw (B) and lock nut securing
the rear arm to the rail.
Back
AG672D
AG673D
FS083A
FS083B
Back to TOC
15. Remove the idler wheel cap; then remove the cap
screw and flat washer securing the rear idler
wheel. Remove the idler wheel; then remove the
adjuster bushing.
NOTE: The adjusting bolt may have to be loos-
ened to remove the adjuster bushing.
NOTE: At this point, the slide rail should be free
o f t h e s k i d f r a m e c o m p o n e n t s a n d c a n b e
removed.
NOTE: If applicable, remove the cap screw and
lock nut securing the coupler block to the slide
rail.
Back to Section TOC
FC194
AG628D
9
AG525D
Next
9-79