Starter Motor (660 Cc) - Arctic Cat 660 cc Service Manual

NOTE: Some ignition-switch terminals may not
be labeled (-M, +M, A, B, or S). Refer to the wiring
harness diagram of the ignition switch when con-
necting the ohmmeter.
Starter Motor
DISASSEMBLING
1. Remove the solenoid nut securing the starter wire
strap to the solenoid. Pull the wire strap away
from the cap screws securing the solenoid to the
starter motor.
2. Remove the two cap screws securing the solenoid
to the starter motor.
Back
(660 cc)
Back to TOC
3. Tip the solenoid back and unhook the pinion lever;
then pull the solenoid out and away from the
starter motor.
0000-126
4. Remove the two through-bolts securing the end
cap to the commutator case; then remove the end
cap.
AO281
5. Check for corresponding alignment marks on the
commutator case and the commutator cap for
assembling purposes.
NOTE: The alignment mark on the commutator
case must align with its corresponding mark on
the commutator cap during assembling. If no
alignment marks exist, scribe corresponding
alignment marks on the case and cap.
AO282
Back to Section TOC
AO283
5
AO284
AO285
Next
5-5