Arctic Cat 660 cc Service Manual page 216

4. Slide the driven pulley off the driven shaft; then
remove pulley from the engine compartment.
NOTE: If the driven pulley is tight on the shaft,
pull the driven pulley off using the Driven Pulley
Puller (p/n 0744-023).
5. Remove the key, alignment washers, and stub
shaft from the driven shaft.
DISASSEMBLING
1. Scribe a line across all driven pulley components
to ensure correct assembly and pulley balance.
2. Place the driven pulley on a work fixture so the
roller plate is directed upward.
NOTE: To aid in driven pulley servicing, use a
roll of duct tape as a work fixture. The work fixture
will increase the stability of the pulley during the
repair procedure.
Back
8-16
AF120D
SC001D
SC002D
Back to TOC
3. Remove the three lock nuts securing the roller
plate; then carefully slide the plate off the
stationary shaft allowing the spring to release
tension.
! WARNING
The roller plate is under spring pressure. Care must
be taken when removing the lock nuts to prevent
the plate from ejecting prematurely.
4. Remove the spring.
5. Slide the movable sheave off the stationary shaft;
then remove any thrust washers located between
the sheaves noting the position of washers for
assembling purposes.
Back to Section TOC
SC003D
B458D
B459D
Next