Arctic Cat 660 cc Service Manual page 323

11. Note the mounting location for installing pur-
poses; then remove the cap screw and lock nut
securing the rear inner idler wheels and mounting
block.
12. Mark the location of the rear coupler block (if
applicable); then remove the block. Account for
the block, bushing, cap screw, and lock nut.
13. Mark the mounting positions of the rear arm lim-
iter (A) and rear arm (B); then remove the cap
screws, lock washers, and lock nuts from the rear
arm limiter and rear arm.
Back
9-50
AG638D
AG672D
FS083A
Back to TOC
14. Remove the idler wheel insert; then remove the
cap screw and flat washer securing the rear idler
wheel. Remove the idler wheel; then remove the
adjuster bushing.
NOTE: The adjusting bolt may have to be loos-
ened to remove the adjuster bushing.
Back to Section TOC
FS083B
AG626D
AG551D
Next