Arctic Cat 660 cc Service Manual page 258

4. Inspect the brake fluid hose for cracks,
deterioration, and the condition of the fittings
(threaded and compression).
ASSEMBLING
KEY
1. Brake Assy
2. Brake Lever
3. Lever Mounting
Screw
4. Lock Nut
5. Reservoir
6. Gasket
7. Cover
8. Screw
1. Apply approved high temperature brake fluid to
the O-ring seal; then install the seal on the
reservoir.
2. Install the reservoir on the master cylinder. Secure
with two screws.
Back
8-58
9. Machine Screw 16. Dimmer Control
Housing
10. O-Ring
17. Switch Assy
11. Master Cylinder
18. Dimmer Knob
12. Lock Washer
19. Handwarmer
13. Screw
Switch
14. Clamp
20. Cover Plate
15. Dimmer Control
21. Self-Tapping
Assy
Screw
22. Brakeline
Back to TOC
3. Install the brake lever. Secure with a screw and a
new lock nut. Tighten the lock nut just to the point
of ensuring free brake lever movement.
Do not over-tighten the lock nut. Over-tightening
the lock nut will cause the brake lever to bind. The
lever must work freely and fully return to its stop
after installation.
0737-603
A new lock nut must be used to secure the brake
AF207
lever.
INSTALLING
1. Position the brake assembly on the handlebar.
Secure with two torx-head machine screws and
clamp; tighten securely.
2. Install the hose on the master cylinder. Tighten
securely.
Back to Section TOC
! WARNING
! WARNING
AF205
AF202
Next