Arctic Cat 660 cc Service Manual page 210

9. Using a small torch, heat the threaded area of the
spider. Place the Spider Removal Tool (p/n 0644-
085) over the heated spider and break spider loose
by turning it counterclockwise.
NOTE: Applying heat to the spider threaded area
will aid in clutch disassembly. The heat will loosen
the Loctite used during assembly.
10. Remove the drive clutch from the clutch holder
using the clutch puller and the same procedure as
pulling the drive clutch from the crankshaft.
Back
8-10
FC085
AM067D
FC086
Back to TOC
11. Remove the spider, spacer washers, and movable
sheave.
12. Using a pair of pliers, remove the six spider
buttons.
13. Using a punch, push each pin from the roller.
Account for the roller washers (one on each side of
each roller).
14. On the 9-post style, remove the three cam arm pins
and lock nuts securing the cam arms to the
movable sheave; then remove each cam arm and
account for the bushings and the washers.
KEY
1. Lock Nut
2. Cam Arm
3. Bushing
4. Washer
5. Pin
Back to Section TOC
AM070D
AM071D
733-452B
Next