Arctic Cat 660 cc Service Manual page 246

5. While holding the end cap in position, remove the
three cap screws securing the end cap to the
adjuster housing.
6. Slowly and carefully lift the end cap from the
adjuster housing until it is free of the hooked end
of the spring.
7. Remove the O-ring seal from the adjuster housing.
8. Carefully lift the spring from the housing and
secure the spring using a cable tie.
Back
8-46
AF401
AF419
AF420
Back to TOC
9. Remove the set screw from the adjuster housing;
then remove the adjuster socket from the housing
by pulling it free of the adjuster bolt.
10. Rotate the adjuster bolt counterclockwise until it is
free of the housing; then remove the adjuster bolt.
11. Wash all components in parts-cleaning solvent and
inspect all components for any signs of wear.
ASSEMBLING AND INSTALLING
1. Apply a light coat of oil to the threads of the
adjuster bolt; then turn the adjuster bolt clockwise
into the housing a few turns.
Back to Section TOC
AF421
AF422
AF423
Next