Belly Pan - Arctic Cat 660 cc Service Manual

INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect for gouges, cuts, and tears.
2. Inspect the two belly pan threaded bosses and
ensure that they are in good shape.
INSTALLING
1. Slide the belly pan into position on the front end;
then secure with cap screws, lock washers, and
washers (forward) and Phillips-head screws
(rearward).
2. Install the three belly pan rivets in each ski-well.
3. Using a piece of cardboard to protect the finish, tip
the snowmobile on its side and install the
remaining belly pan rivets; then return the
snowmobile to the upright position.
4. Install the hood.

Belly Pan

NOTE: The following procedure is for a typical
Arctic Cat snowmobile belly pan. Some compo-
nents will vary from model to model. The techni-
cian should use discretion and sound judgment.
REMOVING LEFT-SIDE
1. Remove the left-side louver.
2. Remove the left-side louver foam.
Back
AL170D
Back to TOC
3. Remove the left-side cap screw securing the
bumper to the air-intake silencer plenum.
4. Open the belt guard; then remove the speedometer
cable from the speedometer drive.
5. On the Bearcat, cut the cable ties securing the
speedometer cable to the belly pan; then route the
speedometer cable away from the belt guard.
6. Remove the left-side front belly pan cap screw.
7. Using a piece of cardboard to protect the finish, tip
the snowmobile on the right side; then remove the
torx-head screws securing the belly pan to the
frame and tunnel.
Back to Section TOC
AL171D
AL172D
7
AL173D
Next
7-25