Arctic Cat 660 cc Service Manual page 350

2. Remove the machine screw and lock nut securing
the wear strip to the front of the slide rail.
3. Using a pipe wrench and starting from either end,
hook the edge of the wear strip with the pipe
wrench jaw and twist the wear strip off the slide
rail. Move the pipe wrench 7.5 cm (3 in.) and
again twist the wear strip off the rail. Repeat this
procedure until the wear strip is free of the rail.
NOTE: The wear strip can also be driven off the
slide rail; however, it is quicker to use the pipe
wrench.
4. Remove the cap screws securing the crossbraces to
the slide rail.
Back
AG506D
AG509D
AG510D
Back to TOC
5. Remove the cap screws and lock nuts securing the
front outer idler wheel and the idler wheel mount-
ing block. Account for flat washers and an axle.
6. Remove the cap screw and lock washer securing
the front inner idler wheel.
Back to Section TOC
AG511D
AG678D
AG686D
9
AG687D
Next
9-77