Console; Belly Pan (120 Cc Model) - Arctic Cat 660 cc Service Manual

Console

KEY
1. Console
2. Door
3. Ignition Switch
4. Key
5. Washer
6. Lock Washer
REMOVING
1. Remove the self-tapping screws securing the
console; then raise the console.
2. Disconnect the wiring harness from the ignition
switch.
3. Remove the console.
INSTALLING
1. Place the console into position.
2. Connect the wiring harness to the ignition switch.
3. Secure the console with the self-tapping screws.
Belly Pan
(120 cc Model)
REMOVING
1. Remove the hood.
2. Remove the two cap screws securing the belly pan
to the front end; then account for washers and lock
washers.
Back
7-24
7. Decal - Right
8. Retaining Nut
9. Self-Tapping Screw
10. Decal - Left
11. Outlet w/Nut
0738-780
Back to TOC
3. Remove the two Phillips-head screws securing the
belly pan to the footrest supports.
4. Using a piece of cardboard to protect the finish, tip
the snowmobile on the right side and using a #20
drill bit, drill out the belly pan rivets.
NOTE: It is not necessary to remove the tie rod
boots.
5. Using a piece of cardboard to protect the finish, tip
the snowmobile on the left side and using a #20
drill bit, drill out the belly pan rivets.
6. With all belly pan rivets removed, return the
snowmobile to the upright position; then slide the
belly pan forward and up until it clears the front
end.
Back to Section TOC
A039A
A040
AL174D
Next