Arctic Cat 660 cc Service Manual page 207

3. Using the Clutch Puller (p/n 0644-207) and an
impact wrench or a breaker bar and the Drive
Clutch Spanner Wrench (p/n 0644-136), tighten
the puller. If the drive clutch will not release,
sharply strike the head of the puller. Repeat this
step until the clutch releases.
4. Remove the drive clutch from the engine
compartment. Account for any spacers.
REMOVING (6-Post Style)
1. Open the belt guard; then remove the drive belt
and the plug from the belly pan.
NOTE: For removing drive belt on models with
the ACT Roller Driven Pulley, see Removing/
Installing Drive Belt in this section.
2. Remove the bolt and lock washer securing the
drive clutch to the crankshaft.
3. Using Clutch
compress the movable sheave inward; then insert
the compressor clamp and slowly release the
compressor locking the movable sheave.
Back
Compressor (p/n 0644-420),
Back to TOC
AN381D
NOTE: Before installing the clutch puller, apply
oil to the threads of the puller and a small amount
of grease to the tip of the puller.
4. Using the Clutch Puller (p/n 0644-207) and an
impact wrench or a breaker bar and the Drive
Clutch Spanner Wrench (p/n 0644-136), tighten
the puller. If the drive clutch will not release,
sharply strike the head of the puller. Repeat this
step until the clutch releases.
FC002A
5. Remove the drive clutch from the engine
compartment. Account for any spacers.
Back to Section TOC
FC260
FC261
8
FC002
Next
8-7