Arctic Cat 660 cc Service Manual page 132

KEY
1. Seat Assy
2. Gas Tank/Seat-Base
Assy
3. Plug
4. Teflon Tape
5. Vent
6. Grommet
7. Tank Cap
8. Seal
9. Cover
10. Seat Wire
11. Insert
12. Insert
13. Self-Tapping Screw
14. Staple
15. Foam
16. Seat Wire
17. Washer
18. Self-Tapping Screw
19. Cap Screw
20. Lock Nut
21. Washer
22. Lock Nut
23. Protector Cap
24. Taillight w/Socket
25. Blub
26. Gasket
27. Lens
28. Retaining Screw
29. Wire Clamp
30. Lock Nut
31. Seal
32. Routing Clip
33. Hose
34. Clamp
REMOVING (Touring/Trail)
NOTE: If applicable, remove the backrest and
rack (see Section 7).
1. Remove the console (see Section 7).
2. Remove the two cap screws, washers, and lock
nuts (located in the rear compartment) securing the
seat to the tunnel.
3. Remove the vent hose from the gas tank.
4. Disconnect the wiring harness from the fuel pump.
! CAUTION
Since the fuel supply hose may be under
pressure, remove it slowly to release the
pressure. Place an absorbent towel around the
connection to absorb fuel.
5. Label the fuel hoses "supply" and "return"; then
remove the hoses from the fuel pump.
6. Raise the rear of the seat high enough to
disconnect the taillight wiring harness; then
remove the seat.
Back
Back to TOC
INSTALLING (Touring/Trail)
1. Place the seat in position on the tunnel; then
connect the taillight wiring harness.
2. Connect the vent hose to the gas tank.
3. Connect the fuel supply and return hoses to the
fuel pump. Secure with clamps.
NOTE: The fuel hoses must be connected to
their respective fittings and tightened securely or
leakage will result.
4. Attach the wiring harness to the fuel pump.
5. Secure the seat to the tunnel with two screws,
washers, and lock nuts.
6. Install the console (see Section 7).
NOTE: If applicable, install the backrest and rack
(see Section 7).
Back to Section TOC
4
0739-024
Next
4-19