INSTALLING
1. Install the shock pads and then secure with new
push nuts.
2. Secure the track adjuster bracket with the cap
screws and lock nuts. Tighten to 1.5 kg-m
(11 ft-lb).
3. Place the rail into position; then install the adjuster
bushing and rear idler wheel. Secure with a cap
screw (coated with red Loctite #271) and flat
washer. Tighten to 3.2 kg-m (23 ft-lb); then install
the wheel cap.
Back
AG527D
AG628D
FC194
Back to TOC
4. If applicable, install coupler block w/bushing.
Secure with cap screws and lock nuts. Tighten to
2.1 kg-m (15 ft-lb).
5. Install the rear arm limiter cap screw (coated with
red Loctite #271) in the appropriate hole (A) (as
noted during disassembly) and tighten to 3.2 kg-m
(23 ft-lb).
6. Install the rear arm in the appropriate hole (B) as
noted during disassembly; then secure with a cap
screw (coated with red Loctite #271) and lock nut.
Tighten to 3.2 kg-m (23 ft-lb).
Back to Section TOC
FS083C
FS083A
9
Next
9-81