Arctic Cat 660 cc Service Manual page 163

2. Place the steering post into position in the engine
compartment and secure the tie rods to the steering
post with washers and lock nuts. Tighten to 2.5-
2.8 kg-m (18-20 ft-lb).
NOTE: Use an additional wrench to keep the tie
rod end shaft from turning while tightening the tie
rod lock nut.
3. Slide the end of the steering post into the lower
steering post bearing and place the upper end of
the steering post on the support.
4. Place the upper steering post bearing into position
on the steering post and secure the steering post/
bearing assembly to the support with the bearing
retainer, cap screws, and lock nuts.
5. Tighten the upper and lower retainer cap screws
securely.
NOTE: Check all fasteners to ensure they are
tight. Turn the handlebar full-left and full-right sev-
eral times to ensure free movement.
Back
7-4
A025
A026
Back to TOC
6. Apply Handlebar Adhesive (p/n 0636-071) to the
bore of the handlebar grip; then using a rubber
hammer, drive the grip into position.
! WARNING
The handlebar adhesive is extremely flammable.
This product contains
released can be easily ignited. Keep away from
heat, sparks, and open flame. Use only in a well
ventilated area. Avoid prolonged breathing of
vapor. Avoid eye and skin contact. Keep container
closed when not in use.
7. Place the emergency stop switch onto the right
handlebar and secure with the screw.
8. Route the throttle cable through the slot in the
throttle control and insert the cable end into the
throttle control. Secure the cable with a C-clip.
9. Seat each cable drum into its lever recess; then
secure each with a pin and C-clip.
Back to Section TOC
acetone. The vapors
A981
A982
Next