Front And Back Wall Preparation - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 1: Front and Back Wall Prep
Part 1
It is important to assemble the frame on a flat, smooth surface.
A: Place (2771) End Post and (2770) End Post Left side by side with the grooves facing up and in. Put (2770)
End Post Left on the right hand side. Place (2775) Panel Cross Support in the top grooves, (2772) Panel Floor
Support in the middle grooves and (2769) Panel BT Frame in the bottom grooves. (fig. 1.1).
B: Make sure assembly is square then attach with 4 (S30) Wood Screws per board. (fig. 1.1)
C: Tap 3 (TN1) T-nuts in (2775) Panel Cross Support and (2772) Panel Floor Support and 2 in (2769) Panel BT
Frame. (fig. 1.1 and 1.2)
Fig. 1.1
2775
Top
Flush
TN1
x 3
Fig. 1.2
TN1
Wood Parts
2 x End Post
2771
2 x End Post Left
2770
2 x Panel Cross Support
2775
2 x Panel Floor Support
2772
2 x Panel BT Frame
2769
S30
x 4
2770
TN1
x 3
2771
Hardware
24 x Wood Screw
S30
16 x T-nut
TN1
19
S30
x 4 per
board
2772
Flush
2769
Bottom
TN1
x 2