Front And Back Wall Prep - KidKraft Summerhill F29050 Installation And Operating Instructions Manual

Step 2: Front and Back Wall Prep
Part 1
It is important to assemble the frame on a flat, smooth surface.
A: Place (2771) End Post and (2770) End Post Left side by side with the grooves facing up and in. Put (2770)
End Post Left on the right hand side. Place (2775) Panel Cross Support in the top grooves, (2772) Panel Floor
Support in the middle grooves and (2769) Panel BT Frame in the bottom grooves. (fig. 2.1).
B: Make sure assembly is square then attach with 4 (S30) #8 x 1-1/16" Wood Screws per board. (fig. 2.1)
C: Tap 3 (TN1) 1/4" T-nuts in (2775) Panel Cross Support and (2772) Panel Floor Support and 2 in (2769) Panel
BT Frame. (fig. 2.1 and 2.2)
Fig. 2.1
S30
2775
Top
Flush
TN1
x 3
Fig. 2.2
TN1
Wood Parts
2 x End Post 31.8 x 63.5 x 2209.8 mm
2771
2 x End Post Left 31.8 x 63.5 x 2209.8 mm
2770
2 x Panel Cross Support 31.8 x 76.2 x 1066.8mm
2775
2 x Panel Floor Support 31.8 x 76.2 x 1066.8mm
2772
2 x Panel BT Frame 31.8 x 76.2 x 1066.8mm
2769
2770
x 4
2772
TN1
x 3
2771
Hardware
24 x #8 x 1-1/16" Wood Screw
S30
16 x 1/4" T-nut
TN1
17
S30
x 4 per
board
2769
Flush
x 2
TN1
Bottom