Back Frame Assembly - KidKraft WINDALE Installation And Operating Instructions Manual

Step 10: Back Frame Assembly
A: On the opposite side of the assembly loosely attach (2210) Front Back Ground to the (2215) Posts with 2
(H4) 1/4 x 4" Hex Bolts (with lock washer, flat washer and t-nut). (fig. 10.1)
B: Loosely attach (1894) Back Floor to both (2215) Posts using 2 (H5) 1/4 x 4-1/2" Hex Bolts (with lock washer,
flat washer and t-nut). The bolt on the Swing Wall side must be installed from inside the fort. Notice the middle
bolt hole is towards the bottom of the board. (fig. 10.1)
C: Attach (2200) Back Divider to (1894) Back Floor with 1 (H1) 1/4 x 1-1/2" Hex Bolt (with lock washer, flat
washer and t-nut) and to (1906) Top Front Back with 1 (PB2) 1/4 x 1-1/4" Pan Bolt (with lock washer, flat washer
and t-nut). (fig. 10.1)
D: Make sure (1906) Top Front Back is level then attach to both (2215) Posts using 4 (S7) #12 x 2" Pan Screws
(with 3/16" flat washers). (fig. 10.1)
E: Tighten all bolts.
Notice hole towards
bottom of board
Wood Parts
1 x Front Back Ground 1 x 4 x 53"
2210
1 x Back Floor 5/4 x 4 x 38-1/2"
1894
1 x Back Divider 1 x 4 x 39-3/16"
2200
1 x Top Front Back 1 x 4 x 38-1/2"
1906
Assemble Back Wall
Fig. 10.1
2200
H5
4 x #12 x 2" Pan Screw (3/16" flat washer)
S7
1 x 1/4 x 1-1/4" Pan Bolt
PB2
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
1 x 1/4 x 1-1/2" Hex Bolt
H1
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2215
2210
Hardware
26
Swing Wall
1906
x 4
S7
with 3/16"
flat washer
PB2
H5
1/4"
t-nut
1894
H1
1/4"
t-nut
1/4" flat
washer
1/4" lock
washer
H4
2 x 1/4 x 4" Hex Bolt
H4
(1/4" lock washer, 1/4" flat washer,
1/4" t-nut)
2 x 1/4 x 4-1/2" Hex Bolt
H5
(1/4" lock washer, 1/4" flat washer,
1/4" t-nut)