Back Wall Assembly - KidKraft BOULDER STATION Installation And Operating Instructions Manual

Step 9: Back Wall Assembly
Part 1
A: Loosely attach 1 (2180) Post and 1 (2336) Centre Post to (2342) Ground Back with 2 (H2) 1/4 x 2" Hex Bolts
(with lock washer, flat washer and t-nut) per board. Make sure the bevelled end of (2180) Post is facing up.
Notice hole orientation of board. (fig. 9.1 and 9.2)
B: Loosely attach (2164) Floor Support to (2180) Post and (2336) Centre Post, on front of assembly, with 2
(H11) 1/4 x 2-3/4" Hex Bolts (with lock washer, flat washer and t-nut). (fig. 9.1)
C: With bevelled ends facing up loosely attach 2 (2181) Short Posts to (2164) Floor Support with 1 (H11) 1/4 x
2-3/4" Hex Bolt (with lock washer, flat washer and t-nut) per board. (fig. 9.1)
Fig. 9.1
2181
H11
2336
Notice screw hole on
this side at bottom.
Wood Parts
1 x Ground Back 1 x 5 x 87-1/8"
2342
1 x Post 2 x 4 x 103-3/4"
2180
2 x Short Post 2 x 4 x 49-3/4"
2181
1 x Centre Post 2 x 4 x 88-3/4"
2336
1 x Floor Support 2 x 4 x 69-1/2"
2164
2181
2164
H11
H2
2342
Inside View
Hardware
4 x 1/4 x 2" Hex Bolt
H2
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
4 x 1/4 x 2-3/4" Hex Bolt
H11
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
31
Notice bevelled
edge facing up
2180
2342
1/4" t-nut
Fig. 9.2
2180
H2
1/4" lock
washer
1/4" flat
washer